August 16, 2018

Why weigh broilers?

To meet processors’ demands, you need to get your broilers into the factory on the preprogrammed

day, close to target weight. Factories are now getting more precise as to what

they want growers to achieve. On farm weighing helps you to meet these requirements.


There are two types of weighings

A) Spot weighings

These are occasional weighings and give a snapshot picture of the situation at the time they

are taken. They may be used in the last week or two, just to check that your broilers will be

bear to the final target weight. Or they can take place at intervals through the crop to check

that the weight for age is in line with the breeder’ target for that age. In other words, to see if

they are growing along the growth curve recommended by the breed company supplying the


The logic of this is that if you can keep them on or close to this prescribed growth curve all

the time, they WILL be on target weight at kill!


B) Regular daily weighings

If you can weigh birds every day, you not only see if they are on the target weight for that

day, BUT you can also see that the daily Live Weight Gain (LWG) is on target. Any fall off in

daily LWG can give an early sign of impending disease or of a management problem.


How to weigh broilers

1) Hand weighing

Young broilers can be weighed in groups of 10, 20, 40 etc depending on their age and size of

the container you use to weigh them in. This is normally slung or suspended from a

mechanical scale from the ceiling. This method is reasonably quick, and does not stress the

birds too much. We only need to know the average weight, so weighing the container full of

birds, then subtracting the weight of the container empty and dividing this by the number of

birds in the container, will give you the average weight. If you do this a number of times in

different parts of the house, you will get a series of average weights. Taking the average of

these will give you the best estimate of the house average. Bigger broilers need to be weighed

individually. Some people put a loop of cord round their two feet and suspend them upside

down from a scale hung from the ceiling. Broilers don’t like this and struggle and flap,

making it difficult to read the scale properly. It is also very stressful to the birds and it takes

them time to get over the trauma before they start growing normally again. There are openended

weighing cones on the market, which hang from the scale. You put a bird into this head

first, and the sides of the cone stop their wings flapping.


Practical problems

A) The procedure is stressful to birds and slows their growth.

B) It is a time consuming and labour intensive method, not suitable for large-scale



Statistical problems

A) Number of birds

All birds in the flock do not weigh the same. Normally about two thirds of the birds are within

10% of the flock average, with about one sixth being more than 10% better than average and

one sixth being more than 10% worse than average. We want to estimate the average weight

of all the birds in the house by weighing a sample.


Distribution of liveweights in a flock of as-hatched broilers (source: Ross)



How many to weigh?

If you only weighed just one bird at random, then clearly, 2/3 of the time your estimate would

be only within 10% of the true flock average. This is not good enough, so you must weigh

more. Table 1 shows you how your estimate of the house average improves the more you

weigh. So, for example, if you weigh 100 birds at random, you will get an average within 1%

of the true house average within 2/3 of the time.


B) Bias

Catchers tend to catch heavier birds because the smaller ones get away! So the estimate of

flock average may be too optimistic.


2) Automatic bird weighing


1) No stress on the birds. Some scales are attractive to the birds because they like to hop

up to a higher level.

2) Can get weights every day.

3) Large numbers are weighed, so the estimate of the house average is good.

4) Better mathematics can be build into the software programme involved to estimate the

true average better.

5) Data can be observed on the control box in the broiler house or on a computer in your

office via a cable linked to a large number of control boxes in different broiler houses.

6) These weights can be shown as graphs. For example:

• Actual daily weights compared to the breed target growth curve.

• Percentage deviation from each day’s target.

• Daily LWG compared to breed target.

7) Data and graphs can be accessed, via a modem from a remote computer, (say in the

farmer’s house or a company head office).

8) Can be incorporated into management and nutrition control systems for profit





There is a capital cost of installation of the equipment, though maintenance cost can be low.


Types of automatic weighers

A) Platform weighers

These are normally metal boxes, which are placed on the litter and are linked by a cable to a

control box in the broiler house. They weigh one bird at the time and are self-tareing when no

birds are on the scale. In other words the empty weight of the scale is zeroed each time to

allow for build up of muck on the scale.

When a bird gets on the scale, the scale records a higher weight. It allows for oscillation in the

recorded weight, and when the weight is stable, it will be recorded if it meets certain criteria.

The weight has to be within a set percentage of the expected weight for that day. If it is not,

(for example, if two or more birds go on the same time), the weight is discarded as not valid

weight. These scales can give reasonable accurate estimates of the average weight.


Disadvantages of a platform weigher

1) The scale has to be empty of birds before the next bird weight is recorded. So if

several birds stay on the scale for some time, no weighings are possible before they

ALL get off!

2) 2) The load cell and the electronic equipment in the platform weigher itself are near

the litter where a build up of dampness and ammonia may take place. Over time, this

can get into the electronics and cause failure.

3) A cable has to lead from the scale to the control box. At least part of this is on or under

the litter, and can be damaged by birds or otherwise.


B) Hanging scales

These work on a different principle. They comprise a larger, 50 cm round platform suspended

via load cell and electronics from the ceiling. The platform is fixed in the centre which

enables the birds to get on and off from all directions (see picture). Many birds can be on the

platform at the same time, depending on their size.

A weight is recorded when a birds gets OFF the scale! As before, a stable weight has to be

recorded before and after the bird gets off, and the weight has to be within a prescribed

bandwidth. So if two birds get off together, no weight is recorded. Build up of muck on the

scale does not matter, as it is the difference in weight that is recorded.



1. Produces more valid recorded weights than floor scales so the estimate average is


2. Broilers like to hop up to a higher level, so the scale is occupied most of the time.

3. The electronic and load cell are in the ceiling, well out of wet and ammonia, and is in

situ between crops.

4. Cables are permanently fixed from the load cell and electronics, back to the control

box, out of reach of the birds and are much less likely to be damaged.



1. Total weight on the scale can be high, so a really secure fixing to the ceiling is

required. A flimsy screw hook can be pulled out.

2. The capital cost may be higher.


Current use of broiler scales

Hundreds are now in use in Europe and in America. Major companies are examining the

various options and some are now buying in volume.


The future

We will need to get broilers to market age at more exact weights, (at least to within 2% of the

target), to meet supermarket and consumer demand. To do this we will need to exercise better

management control of broiler growing.

Whatever the industry, you cannot exercise management control if you do not have accurate

management information!

Knowing what your broilers weigh on a day to day basis is essential if you want to get them to

market age on the target weight in the best, most cost effective way.

If you see deviations from the proper growth curve starting to develop, you have the

opportunity to do something about it quick enough to get them back on the correct growth

curve again.

Without this information, you may not even know there is a problem until it may be too late to

do anything about it!

What to do about it may involve looking at the daily feed intakes and the daily nutrient

intakes of the birds compared to breed targets. There are proven computer programmes

available to help you do just that like the OptiLink software from OPTICON.


Contact us for more information


No of weighings


Percent of time

Average weight

400 gram

Average weight

800 gram

Average weight

1600 gram


Within 10%

40 g

80 g

160 g


Within 5%

20 g

40 g

80 g


Within 2,5%

10 g

20 g

40 g


Within 1%

4 g

8 g

16 g


Within 0,5%

2 g

4 g

8 g

Table 1 Limits of Accuracy related to Average weight (source: Flockman, Ross, Cobb)